When replacing the transmission parts of the copper wire drawing machine, the following key details need to be paid attention to to ensure the smooth replacement process and the stable operation of the equipment after replacement:

1. Preparation

1. Shutdown and power off: First of all, you must ensure that the equipment has been completely shut down, and cut off all power to avoid accidental start or electric shock accidents during the replacement process.

2. Tools: Prepare required tools, such as wrenches, screwdrivers, and sleeves, and ensure that these tools are in good condition to facilitate the removal and installation.

3. Spare parts inspection: Check whether the new transmission parts meet the requirements of the equipment, including model, specification, material, etc., to ensure that the spare parts match the original parts of the equipment:

2. Disassemble the old parts

1. Mark and record: Before disassembly, mark and record the position, installation direction and tightening degree of the transmission parts for reference when installing new parts.

2. Gradual disassembly: Remove the old parts step by step according to the instructions of the equipment or technical personnel. Take care not to damage surrounding parts or structures, and keep the work area clean and tidy.

3. Cleaning and inspection: After disassembly, clean the installation site to remove impurities such as old oil stains and iron filings. At the same time, check whether the installation site is worn or damaged, and repair it if necessary.

3. Install new parts

1. Alignment and installation: Align the new component with the installation position and install it according to the marks and records made during disassembly. Make sure the parts are installed in place and check that their movement is flexible.

2. Fastening and adjustment: Tighten the fasteners according to the specified torque and sequence to avoid too tight or too loose. At the same time, the new parts are adjusted as needed to ensure that they work well with other parts.

3. Lubrication and testing: After the installation of new parts, they are lubricated to reduce friction and wear. Then start the equipment for trial operation to check whether the operation of the new parts is normal, whether there is abnormal noise or vibration and other abnormal phenomena.

4. Precautions

1. Safety first: During the entire replacement process, safety operation procedures must be strictly observed, and personal protective equipment must be worn to ensure personal safety.

2. Professional operation: It is recommended that the transmission parts be replaced by technicians with professional knowledge and experience to ensure the accuracy and efficiency of the replacement process.

3. Follow the manufacturer's instructions: During the replacement process, refer to the device manual or consult the manufacturer's technical personnel, and follow the manufacturer's instructions and suggestions.

4. Spare parts management: The old parts should be properly kept or disposed of, and the new parts should be stored and managed for subsequent use and maintenance.

By paying attention to and following the above details, we can ensure the smooth replacement process of the transmission parts of the copper wire drawing machine, and ensure the stable operation and long-term use effect of the replaced equipment.